1. Starting from one side of your nail bed, measure across the widest part of your natural nail horizontally with soft tape ruler. Record the measurement for each nail.

2. On the piece of paper, jot down the measurements for each of your nails. It's helpful to label them (e.g., thumb, index, middle, ring, pinky) to keep track.

3. Double check your measurements. Ensure accuracy by confirming the size of each nail.

4. Match your measurements with the available sizes provided in the press-on nail kit. Choose the sizes that closely align with your nail measurements. (If needed, you can file or trim the press-on nails slightly for a more precise fit.)

 

WHAT IF I DON'T HAVE A SOFT TAPE RULER???

If you don't have a soft tape ruler, you can also use a soft tissue paper to measure your nails size! Place a tissue strip horizontally across the widest part of your nail bed. Gently press the tissue to the sides to match the width of your nail. Once it aligns with the width, mark or crease the edges where it meets the sides of your nail. Carefully remove the tissue strip and measure the marked areas using a ruler then you can get your size of your nails! :)

Step 1: Prep Your Natural Nails
Start with clean, dry nails. Remove any existing nail polish and gently push back your cuticles for a smooth application surface.

Step 2: Apply Adhesive
Use the adhesive tabs or glue provided in your kit.

-Adhesive tabs: 

1. Select the right size of the adhesive tabs that can cover your nails.

2. Carefully peel the adhesive tabs from the sheet using tweezers or your fingers. Be gentle to avoid damaging the tabs.

3. Place the adhesive tab on your natural nail, aligning it with the cuticle and ensuring it covers the entire nail bed. Press firmly to secure it in place.

4. Peel off the protective film from the adhesive tab, revealing the sticky surface.

-Glue:

1. Apply a small drop of glue on the press-on nails, then gently press it on your natural nails. Ensuring not to use too much glue in case of spilling the glue onto your skin.

Step 3: Place the Press-On Nail
Align the press-on nail and press it down, starting from the base and holding it firmly in place for a few seconds. Apply slight pressure to ensure a secure bond. Smooth out any air bubbles by pressing gently from the center to the edges of the nail.

Step 4: Repeat the Process
Follow the same procedure for each nail, one at a time, ensuring proper alignment and a snug fit for each press-on nail.

Step 5: Enjoy Your Stunning Nails!
Tada! Flaunt your beautiful nails and enjoy your new look. :)

 

Tips:

-Avoid contact with water for at least 4 hours after application for a stronger bond.

-Once you've applied the adhesive tabs on your natural nails, use a hair dryer to warm them up for a few seconds, it can enhance their adhesive properties which makes your press-on nails stays longer.

-If using glue, be cautious and use it sparingly to prevent excess glue from spilling onto your skin.

-The press-on nail attached with glue is not reusable.

 

Step 1: Loosen the Press-On Nails
Gently lift the edges of the press-on nails using a cuticle stick or a wooden tool. Be cautious to avoid damaging your natural nails.

Step 2: Soak Nails in warm water
Sock your fingers in a cup of warm water (add some oil can help it to remove easier after), ensuring it covers the entire nail surface.

Step 3: Gently Remove Press-On Nails
After soaking, gently use the cuticle stick to loose the press- on nails.

Tips:
-Avoid forcefully pulling off the press-on nails as it can damage your natural nails.
-Store your press-on nails in the box because they are reusable :)